Ice SCRUB 80 D, Руководство по эксплуатации и обслуживанию

Страница: 26 / 32

TROUBLESHOOTING
This chapter lists the most common problems linked with the use of the machine. If you are unable to resolve the problems with the information
given here, please contact your nearest assistance centre.
26
MACHINE CODE QTY BRISTLE NOTES
MxL 65 Bt
422189 2 PPL 0.3 BLUE BRUSH
422971 2 PPL 0.6 WHITE BRUSH
422972 2 PPL 0.9 BLACK BRUSH
422981 2 ABRASIVE GREY BRUSH
422973 2 - PAD HOLDER
MxL 75 Bt
414272 2 PPL 0.3 BLUE BRUSH
414270 2 PPL 0.6 WHITE BRUSH
414273 2 PPL 0.9 BLACK BRUSH
414271 2 ABRASIVE GREY BRUSH
405508 2 - PAD HOLDER
Scrub 80D
445562 2 PPL 0.3 BLUE BRUSH
445563 2 PPL 0.6 WHITE BRUSH
445564 2 PPL 0.9 BLACK BRUSH
445565 2 ABRASIVE GREY BRUSH
421819 2 - PAD HOLDER
MxL 70 Bts
449785 2 PPL 0.3 BLUE BRUSH
448012 2 PPL 0.6 WHITE BRUSH
448013 2 PPL 0.9 BLACK BRUSH
448014 2 ABRASIVE GREY BRUSH
PROBLEM POSSIBLE CAUSE SOLUTION
THE MACHINE
DOES NOT START
The main switch is set to “0”. Make sure the main switch is on “I”. If it isn't, turn the key clockwise.
Check that when switched on there
are no alarm messages on the
command display.
Stop the machine immediately and contact the technician of the specialised
service centre, or press the SOS button if the HFM kit is installed.
Make sure that the batteries are
correctly connected to each other
and that the battery connector is
connected to the electrical system
connector.
Connect the batteries correctly inside the machine (see INSERTING THE
BATTERIES IN THE MACHINE ”).
Check the charge level of the
batteries.
If the battery charge level is critical, perform a complete recharge cycle (see
paragraph CHARGING THE BATTERIES ”).
THE BATTERIES
ARE NOT CHARGED
CORRECTLY
(VERSIONS
WITH AN ON
BOARD BATTERY
CHARGER)
The plug on the battery charger's
cable is not correctly inserted into the
socket on the battery charger itself.
Reconnect the battery charger's power cable.
The plug on the battery charger's
power cable is not correctly inserted
into the electrical outlet.
Check that the battery charger power supply cable plug is connected to the
mains socket.
The characteristics of the mains
power supply do not correspond to
those required by the battery charger.
Check that the characteristics in the battery charger plate are the same as
those of the mains supply.
The LEDs of the battery charger blink
repeatedly.
Referring to the battery charger use and maintenance manual, check the
meaning of the flashing signals that the battery charger emits dung the
battery recharge stage.
THE MACHINE HAS
A VERY LOW WORK
AUTONOMY
Check the battery charge level, check
the symbol on the command display.
If the battery charge level is critical, perform a complete recharge cycle (see
" RECHARGING THE BATTERIES ”).
THE MACHINE
DOES NOT MOVE
The machine does not start. Read the section “ THE MACHINE DOES NOT START ”.
There is an issue on the drive pedal. Contact your nearest service centre.