Specification & Limitations
CD40030/CD40022
Page
5
This dispenser is designed to be installed and operated
indoors, in a controlled
environment.
It’s minimum and maximum operating temperature limits are the same as
those for the ice machine.
Minimum
Maximum
Air Temp
50
o
F
100
o
F
Water Pressure*
20 psi
60 psi * for water dispenser model
Check the dispenser nameplate, located on the back of the cabinet for specific information.
Ice-O-Matic reserves the right to make design changes and/or improvements at any time.
Specifications and designs are subject to change without notice.
Ice-O-Matic assumes no liability or responsibility of any kind for products manufactured by
Ice-O-Matic that have been altered in any way, including the use of any parts and/or other
components not specifically approved by Ice-O-Matic.
Models
There are three versions of the CD40030 dispensers: Basic, Coin/token and Water
Dispenser. The Basic version is constructed to deliver ice when the ice chute is pushed in,
and it continues to vend ice as long as the ice chute is held in or until the bin is empty.
The Coin/token version is designed to deliver ice after a coin or token is inserted into the coin
slot and then the ice chute is pushed in. Ice vending is limited to a preset time per coin or
token use. Coins or tokens are collected in a coin box at the bottom of the dispenser. A keyed
door allows access to the coin box without removing the front panel.
The Water Dispenser version is a Basic version with a mechanical water faucet added to the
left of the ice chute. Water is dispensed whenever the faucet lever is pushed back. The
CD40030 is available in all versions; the CD40022 is only available as a Basic model.
The Basic models of the CD40022 and CD40030 are available in 230 volt 50 Hz electrical for
those countries with that type of electrical service.
Kits: Bin tops and bin thermostats are not required. No other kits are available.
Warranty If, during the warranty period, customer uses a part for this Ice-O-Matic equipment
other than that an unmodified new part purchased directly from Ice-O-Matic, Ice-O-Matic
Distributors, or any of its authorized service agents and/or the part being used is modified
from its original configuration, this warranty will be void. Further, Ice-O-Matic and its affiliates
will not be liable for any claims, damages or expenses incurred by customer which arises
directly or indirectly, in whole or in part, due to the installation of any modified part and/or part
received from an unauthorized service center. Adjustments are not covered under warranty.
Warranty Procedure If the customer is using a part that results in a voided warranty and an
Ice-O-Matic authorized representative travels to the installation address to perform warranty
service, the service representative will advise customer the warranty is void. Such service
call will be billed to the customer at the authorized service center’s then-applicable time and
material rates.
