12
How to Check if your game is in Calibration.
Step 1:
Coin up the game.
Step 2:
Using the Mallet to strike the “Hit Pad” as hard
as you can! (See Illustration).
Step 3:
If the lights travel to the top of the tower, rebound
back down and land in the “Sensitivity Target Zone” then
your game is Calibrated. (see Illustration)
Step 4 :
If the lights do not land in the “Sensitivity Target
Zone” then you will need to adjust OPTION 8 in program-
ming. See A-E below:
A) Open the cabinets front drawer and inside you will find the
User Control Panel.
B)
Press the “PROG” button once and the “Right Balloon” will Dis-
play the option you are adjusting.
IF you accidentally hit a
wrong button and the game is not responding normally…
then turn off/on the game. (cycle power and start over)
C) Press the “SELECT” button until the “Balloon Display” reads 08.
(You will need to press “SELECT” 8 times)
D) Press the “UP” or “Down” button to change the “SENSITIVITY
VALUE” ( The Marquee BONUS DISPLAY on top of the tower
will indicate the new “SENSITIVITY VALUE”. The “Balloon Dis-
play” should remain at 08)
Decrease
the Value of Option 8 if the lights do not rebound off
of the top of the tower. (Degrease Marquee Value Display by
pressing “Down” button)
Increase
the Value of Option 8 if the lights rebound off of the
top of the tower and travel past the “Sensitivity Target
Zone” (Increase Marquee Value Display by pressing “UP” button)
E) Once you have
Increased or Decreased
the Marquee value in
option 8 you must
press the “PROG”
button to exit.
F) Repeat Steps 1—4
until your game is
Calibrated.
IMPORTANT: RECORD ALL SETTINGS ON THE CERTIFICATE LOCATED ON
THE SIDE OF THE FRONT DRAWER - OR— USE THE REVERSE SIDE OF THIS
PAPER IF IT CONTAINS A CALIBRATION CERTIFICATE.
“Sensitiv
ity
Tar
ge
t Z
o
n
e”
** Note ** The
“Sensitivity Target Zone”
is between the two highest numbers on
the Tower’s Score Chart. Your Tower’s
Score Chart might differ from the picture
shown.
NO
T
CAL
IBRA
TE
D
Marquee Display (Change Value)
Increasing Value = Less Rebound
Decreasing Value = More Rebound
Balloon
Display
Option 08
Sensitivity
Setting
STEP 2:
Whack the “Hit Pad” as hard as
you can with the Mallet! (Do this after
you “coin up” the game.)
NO
T
CAL
IBRA
TE
D
All manuals and user guides at all-guides.com
