ICC OPC-PRT3, Инструкция по эксплуатации, Страница: 30 / 115

ICC
29
its internal mirroring memory for that function code. This feature allows for the block access of non-
contiguous registers (function codes) as described in section 4.1. Care must be taken to utilize only the
function codes that are known to exist and that are also specified in the
Manage Device Parameters .
4.3 Commonly Used Function Codes
For a complete listing of all available function codes, their bit mappings, scaling values, etc., please refer
to the applicable inverter
Instruction Manual and the Fuji RS-
485 User’s Manual (24A7-E-0082)
. As a
user convenience, the structures of the commonly-
used “Operation command” (function code S06),
“Operation status” (function code M14) and “Rotation Speed” (function code W08) are replicated here
(refer to Table 15, Table 16 and Table 17, respectively).
Table 15
: Structure of “Operation command” (Function code S06)