VIII. TABLE OF STATUS INDICATOR /
TABEL
STATUS INDIKATOR
BUZZER
LED
NTPL
NTPC
L1
L2
L3
RECOMMENDED
SOLUTION
MAIN
SWITCH
STATUS
CONDITION
Normal
No line voltage
Line voltage too
low
Line voltage too
high
Inverter is on at
low battery voltage
1. Line power is
normal.
2. Low battery.
Check the line power, make sure
between 165-250 Vac.
Check the line power, < 250 Vac.
Save your work now, the inverter
will be cut off.
1
1
1
1
1
1
0
0
1
0
1
-
0
0
0
1
1
0
0
1
0
1
0
0
0
0
1
1
1
1
1
0
1
0
0
0
0
-
-
Remark :
L1 : Green Led (Line On)
NTPL : Audible alarm sound every 4 seconds.
L2 : Yellow Led (Inverter)
NTPC : Audible alarm sound every 1 second.
L3 : Red Led (Battery Low)
VII. START UP UPS /
MENGHIDUPKAN UPS
1. Pastikan tombol pada posisi “off” dan tidak
ada beban yang terpasang pada stopkontak
keluaran.
2. Hubungkan steker kabel daya ke stopkontak
jala-jala yang mempunyai arde.
3. Hidupkan UPS dengan menekan tombol daya.
Led merah TEGANGAN BATERAI RENDAH
akan menyala sekitar 2 detik dan padam
kembali bila kondisi baterai baik. Bersamaan
dengan itu led hijau LISTRIK JALA-JALA
menyala (bila tegangannya > 165V dan
< 250V) yang menunjukkan keluaran UPS
berasal dari listrik jala-jala.
4. Cabut steker kabel daya dari stopkontak jala-
jala maka led hijau LISTRIK JALA-JALA
padam sedangkan led kuning INVERTER akan
menyala dan buzzer akan berbunyi setiap 4
detik.
5. Pasang kembali steker maka sekitar 2 detik
kemudian led kuning INVERTER padam
sedangkan led hijau akan menyala.
6. Sekarang UPS siap menjalankan fungsinya.
Hubungkan peralatan yang akan diberi pasokan
daya pada stopkontak keluaran UPS.
1. Make sure main switch on the “off” position
and no load is connected to the outlet.
2. Connect inlet with power cord to a power
receptacle with earth ground.
3. Turn on the UPS by pressing power button.
The red led of BATTERY LOW lights for
about 2 seconds and will go out when the
battery is in good condition At the same time
the green led of LINE ON light (if line
voltage > 165V and < 250V) which indicates
UPS output is from line power.
4. Disconnect inlet from line power, the green
led of LINE ON will go out while the yellow
led of INVERTER will light on and audible
alarm will sound every 4 seconds.
5. Connect inlet to line power again and then
after about 2 seconds the yellow led of
INVERTER will go out while the green led of
line on will light on.
6. Now your UPS is ready for operation.
Connect the equipment that is going to be
supplied by the UPS into the UPS.
.