5
ADDR
：
001-H
BR
：
9600
PARITY
：
None
VERSION
：
V1.00.0.R
SYSTEM SETTING
DISPLAY SETTING
CAMERA SETTING
FUNCTION SETTING
ALARM SETTING
IR LIGHT SETTUING
EXIT
The above diagram illustrates the overall structure of the speed dome setup menu.
Note:
ERR means current setup is invalid. Please restore factory default setup.
Please make sure all the cable connections are right.
3.2
Self-diagnosis System Information
Figure 3-1
Self-diagnosis
After installation, please connect speed dome to power. The system goes on a self-diagnosis, and then
it pops up the above interface to show the system information.
The above interface disappears after speed dome received the first command (or the display time lasts
for 4 minutes.)
ADDR: Here you can view dome address information. For example, 001-H, -H is the hardware
address number, -S is software address mode.
BR: Dome communication baud rate.
PARITY: Communication parity bit format.
VERSION: Dome software version.
When you are using the control keyboard or the matrix host to control the device, please make
sure the control parameter of the keyboard or the matrix host is the same with the speed dome
OSD (including address, baud rate, parity). Please make sure the cable connection is OK.
3.3
Main Menu
You can open speed dome menu via control keyboard, matrix, or speed dome control terminal.
Figure 3-2 Main menu
SYSTEM SETTING
：
Dome system information, address information, system time, set north
direction, language, factory default setup, and restart and so on.
DISPLAY SETTING: Display dome preset, azimuth display, direction, and dome internal
temperature and etc information.
CAMERA SETTING
：
Display dome white balance setup, exposure setup, day/night setup, focus
setup, image adjustment, zoom speed, aperture setup, aperture restrain level, digital zoom, image
flip, image output mode, factory default setup, camera restart and etc.
FUNCTION SETTING: Set preset, auto pan, auto scan, auto tour, auto pattern, idle motion, privacy
mask and etc.
ALARM SETTING
：
Set dome alarm number, action, parameter, contact, replay out, reset time and
etc.
IR LIGHT SETTING: Set dome IR sensitivity, IR light control, medium and far light bright, far light
