IBP HDC75, Быстрый старт и инструкции по безопасности

Страница: 3 / 12

1 Getting to know the HDC75
The HDC75 is a robust smart device with Windows 10. It has five RS485-Interfaces for the direct connection
of the Biotech-Lab modules.
USB-Interface
Used also for charging the device. For charging use only the Quick-Charge 2.0
compatible charger delivered with the HDC75. If you charge the device with a
different charger the battery charge status of Windows 10 will not working properly
with the increased battery size of the HDC75.
Quick charge and fast charge modes are only entered when the charger is plugged in
while the HDC75 is completely turned off.
Turning on the HDC75 while in proper fast charge mode results in the sensor
ports being inaccessible as long as charging is in progress.
To activate the sensor ports again it is necessary to briefly unplug the USB charger
and then plug it in again. The charge circuit will revert to normal or slow charge
depending on the capabilities of the USB charger.
LED Green Charger connected
LED Red on: Charging with a standard charger at max. 5 V / 1500 mA
LED Red blinking: Charging with Quick-Charge 2.0 mode at up to 12 V / 1500 mA
Power Button
Turn on: Press and hold the
power button about 5 seconds until the green LED gives
you a short blink feedback.
Turn off: Press and hold the
power button until the device switches off.
Lock and unlock
Lock: Press the power button
Unlock: Press the power button to turn on the HDC75, than place your finger on the
lock icon and slide the icon to the unlock position.
RS485-Interface for the connection of the Biotech-Lab modules.
The connector next to the button is the number one and will be shown as the first
sensor in the Biotech-Lab Software.