Note:
Prior to initial operation, the nebulizer should be thoroughly cleaned.
1. Place your Compressor Nebulizer on a flat and stable surface. Be sure that you can easily
reach the controls when you are seated.
2. Open the clear cover and remove the inside accessories.
Important:
Prior to initial operation, the nebulizer should be thoroughly cleaned referring to the "Cleaning
Procedures" in the manual.
3. Gently twist the top part of the nebulizer counter-clockwise to disassemble the nebulizer.
4. Consult with your physician to select an appropriate cone for the best treatment. Insert it to
the bottom of nebulizer.
Cone A for the therapy of the upper respiratory tract
Cone B for the trachea-bronchial therapy
Cone C for the therapy of the deep respiration tract
5. Fill the bottom section of the nebulizer with the medication prescribed by your physician.
6. Gently twist the top part clockwise to re-assemble the nebulizer. Be sure the two sections fit
well.
7. Attach one end of air tube to the base of the nebulizer
8. Attach the other end of air tube to the tube connector located on the front of the compressor.
9. Attach mouthpiece or mask per your choice to the top section of nebulizer.
10. Plug the power cord into an appropriate electrical outlet. Make sure at this stage, the power
switch is at "O" status.
11. Press power switch to begin your prescribed treatment. Adjust the aerosol outflow by
regulating the valve.
Place cone inside and fill medication.
O
PERATING YOUR COMPRESSOR NEBULIZER
14
