13
Rules relating to security
- Install on metal or other non-combustible materials. There is a risk of fire.
- Use away from flammable materials. There is a risk of fire
- Use away from explosives. There is a risk of explosion.
- Check if the grounding is correct and effective. Faulty or incorrect grounding may cause electric shock
shock
- Check whether the power supply complies with the instructions. Incorrect work may result in electric shock or fire
- Turn off the electricity supply before installation or maintenance. Otherwise there is a risk of electric shock
shock.
- Do not touch the inverter with wet hands. There is a risk of electric shock
- If the unused device is stored for more than 2 years during startup, be vigilant and pay attention.
- If abnormal behavior of the device is detected, disconnect it from the power supply immediately. Otherwise it may
result in electric shock
electricity or fire
- Maintenance should start no earlier than 5 minutes after power off when all control
the LEDs will turn off. There is a risk of electric shock
- Do not touch any parts of the electrical system with bare hands when the appliance is plugged in. there
risk of electric shock
- Subassemblies or parts may only be replaced by an authorized service center.
- No metal objects may be left in the device. There is a risk of electric shock or fire.
- Exposed parts of the electronics should be secured with insulating tape. There is a risk of paralysis
shock
- When installing the inverter, make sure that the place where it will be installed is strong enough to
maintain his weight. It may fall and cause property damage or injury
- Install the inverter so that any leakage in the installation does not cause flooding the device with water. inverter
must be protected from water including atmospheric. The inverter must not be installed in exposed rooms
at high humidity. There is a risk of damage to property
- Install the inverter away from direct sunlight. UV radiation increases the risk of damage
property
- The inverter should be installed and stored at room temperature in a dry, cool place
good ventilation
- Good ventilation is necessary at high temperatures or in summer to avoid condensation and dew. There is a risk
destruction of property.
- The inverter should be maintained by a specialist.
- Do not install or operate the inverter if it is damaged or missing components. There is a risk of fire or
operator electric shock
- Secure the inverter after installation. Limit access to it so that it is out of reach of children
- Po instalacji zabezpiecz inwerter. Ogranicz dostęp do niego tak aby był poza zasięgiem dzieci
Environmental requirements
- External conditions have a direct impact on the operation and reliability of the device. For this reason they must be
the following conditions have been met:
- Permissible ambient temp range: from -10 ° C to + 40 ° C
- Use only inside the room
- Install away from corrosive substances and explosive gases
- Install away from flammable materials
- Install in dry and well-ventilated places
- Install in locations out of the reach of electromagnetic interference
- Avoid places dusty or exposed to metal shavings that can get into the controller.
!
INTRODUCTIONS
ATTENTION
Содержание IVR-10
Страница 20: ......
