IBM TotalStorage FAStT700, Руководство по установке

Страница: 23 / 86

v
While the device is still in its static-protective package, touch it to an unpainted
metal part of the system unit for at least two seconds. (This drains static
electricity from the package and from your body.)
v
Remove the device from its package and install it directly into your system unit
without setting it down. If it is necessary to set the device down, place it in its
static-protective package. Do not place the device on your system unit cover or
on a metal table.
v
Take additional care when handling devices during cold weather because heating
reduces indoor humidity and increases static electricity.
Installing the FAStT700 Storage Server in a rack cabinet
The FAStT700 Storage Server comes with a rack-mounting hardware kit for
installation into a rack cabinet. It is easier to lift the FAStT700 Storage Server and
install it in a rack cabinet if you remove all CRUs first. A fully loaded FAStT700
Storage Server with a storage server fan, battery, fan and communications module,
two RAID controllers, two power supplies, and eight mini hubs installed weighs
43.99 kg (97 lbs). If you remove all the CRUs, you reduce the overall weight.
For detailed instructions about removing the CRUs and installing the FAStT700
Storage Server in a rack cabinet, refer to the
Rack Mounting Template and Rack
Mounting Instructions that come with the FAStT700 Storage Server. If you have not
already done so, read “Preparing for installation” on page 6 before you begin.
Installing additional hardware
You might need to install additional hardware if your Fibre Channel network is
configured for the following:
v
Host-agent (in-band) management of storage subsystem
v
Direct (out-of-band) management of storage subsystem
v
Cluster server environment
Use the information in the following sections to determine the additional hardware
that you need.
Chapter 1. Introduction
7