IBM TotalStorage EXP100, Инструкция по установке, использованию и обслуживанию

Страница: 137 / 188

Install the firmware and NVSRAM in the DS4000 using the steps that are
described in “Downloading the controller firmware and NVSRAM” on page
112.
To find out how to verify your current firmware levels, see “Determining
firmware levels” on page 11.
Verify current EXP100 ESM status
In the DS4000 Storage Manager Subsystem Management window, verify
that all EXP100 ESMs are optimal in the configuration that you are
upgrading, and there are not any lost drive path redundancy errors. Correct
any problems using the suggested instructions in the DS4000 Storage
Manager Recovery Guru window.
To verify, either click the Recovery Guru icon in the Subsystem
Management window, or click the Enclosure Status icon in each expansion
enclosure with the red X mark overlay, as displayed in the Physical View.
When you are done, continue to “Downloading the ESM firmware and csb file.”
Downloading the ESM firmware and csb file
Attention
This version of EXP100 ESM firmware requires that you download an
additional csb file after you download the ESM firmware file. If you download
the csb file first, then drives may be marked failed or might not display in the
Physical View of the Storage Subsystem Management window. You could lose
data access or data.
Before you begin: To find out the latest versions of the ESM firmware and csb file
that you need to download, see the IBM EXP100 R1 to R2 ESM firmware upgrade
readme file.
Downloading the ESM firmware
Complete the following steps to download the ESM firmware to the EXP100:
1. In the Subsystem Management window, select Advanced
→
Download
→
Environment Card (ESM) firmware . The Download Environmental (ESM) Card
Firmware window opens.
2. In the Download Environmental (ESM) Card Firmware window, select all of the
expansion enclosures to be updated with new firmware, then click Browse to
open the Select Environmental (ESM) Card Firmware File window.
3. In the Select Environmental (ESM) Card Firmware File window, select the
directory that contains the ESM firmware file, then select the name of the ESM
firmware file. Click OK to close the window and continue.
Note: You might need to select All Files (*.*) in the “Files of type” pull-down
menu to display the correct file name for selection. If you do, then a
warning window opens. Click OK when the warning window opens. You
will need to select the file with the name esm955x.dl.
4. In the Download Environmental (ESM) Card Firmware window, click Start .
When the Confirm Download window opens, type
yes
and click OK . The ESM
Appendix A. Upgrading R1-level firmware (DS4300 and DS4500 only)
111