IBM TotalStorage DS4400, Руководство пользователя

Страница: 80 / 124

Fill in the following information:
v
Date of Installation - Record today’s date on the blank line
v Replacement Date - Record the expiration date (three years from today’s
date) on the blank line
7. Install the new battery.
a. Using both hands, slide the battery about 5 cm (2 in.) into the slot.
b. Using the pull handles, slowly push the battery completely into the slot.
c. Tighten the four captive screws.
8. Replace the DS4400 Storage Server bezel, as shown in Figure 22 on page 23.
9. Run the system for at least 24 hours to properly charge the batteries. The
battery might take up to 15 minutes to complete its self-test and up to 24 hours
to fully charge, especially after a power loss of more than a few minutes.
When properly charged, both full-charge indicator lights on the front of the
battery are lit.
10. Check the battery indicator lights, as shown in Figure 38 on page 49.
Figure 37. Recording the battery support information
48
IBM TotalStorage DS4400 Fibre Channel Storage Server: User’s Guide