IBM TotalStorage DS4300 Turbo, Инструкция по установке и эксплуатации

Страница: 70 / 164

DS4300 single-controller storage server (Model 6LU/6LX)
Connect an Ethernet cable from the storage-management station to the Ethernet
port of the controller.
DS4300 dual-controller storage server (Model 60U/60X)
Connect a pair of Ethernet cables from the storage-management station to the
Ethernet ports for Controller A (located on the left) and Controller B (located on the
right) on the back of the storage server. Figure 38 shows the location of the ports.
Important: The serial interface ports are intended to be used by service technicians
to perform diagnostic operations on the storage server. Inappropriate use will result
in loss of system availability, loss of data, or both.
Power cabling
The DS4300 dual-controller storage server (Model 60U/60X) uses two standard
power cords, and the single-controller storage server (Model 6LU/6LX) uses only
one.
You can connect the power cords to a primary power unit inside the rack, such as a
properly grounded ac distribution unit, or to an external source, such as a properly
grounded electrical outlet.
If you have not already done so, attach the power cords, using the following
illustration for the location of the component parts.
Controller A
Ethernet port Controller A
Serial port Controller B
Serial port Controller B
Ethernet port
Figure 38. Ethernet and serial port locations
AC power
connector
AC power
switch
Strain-relief
clamp
Lever
-
Figure 39. Power cord locations
40
IBM TotalStorage DS4300 Fibre Channel Storage Server: Installation and User’s Guide