IBM TotalStorage DS300, Руководство по установке оборудования и инструкция пользователя

Страница: 19 / 110

v
Rack jumper power cords (one or two depending on storage subsystem model)
v Chassis bezel assembly
Software and documentation (all models)
v
IBM ServeRAID 7.20 Application CD
v
IBM TotalStorage DS300 and DS400 Support CD
v IBM Documentation CD, including:
– IBM TotalStorage DS300 and DS400 Installation and User’s Guide
– IBM TotalStorage DS300 and DS400 Software Installation Guide
– Safety Information document
v Rack Mounting Assembly kit, including:
– Rack Installation Instructions
– Rack mounting template (for aligning the rails properly)
If an item is missing or damaged, contact your IBM reseller or IBM marketing
representative.
If you have not already done so, record the controller serial number in Table 8 on
page 61.
Components of the DS300 and DS400 external storage subsystems
The following sections show the components of the storage subsystem.
The hot-swap features of the storage subsystem enable you to remove and replace
hard disk drives and power-supply-with-fan units without turning off the storage
subsystem. Therefore, you can maintain the availability of the system while a
hot-swap device is removed, installed, or replaced.
Front view
The following illustrations show the components and controls on the front of the
DS300 (1701-1RS) and DS400 storage subsystems.
Note: The illustrations in this document might differ slightly from your hardware.
Hard disk drive
Drive filler panel
Figure 1. DS300 (1701-1RS) and DS400 storage subsystem front components
Chapter 1. Introduction
5