IBM totalstorage 200, Руководство по установке оборудования

Страница: 61 / 152

4. Remove the defective hard drive: move the handle on the hard drive to the
open position (perpendicular to the hard drive) and pull the hot-swap hard drive
assembly from the drive bay.
5. Install the replacement hard drive in the hot-swap drive bay:
a. Ensure the tray handle is open (that is, perpendicular to the hard drive).
b. Align the rails on the hard drive assembly with the guide rails in the drive
bay.
c. Gently push the hard drive assembly into the drive bay until the hard drive
connects to the backplane.
d. Push the tray handle toward the closed position until it locks the hard drive
in place.
6. Check the hard drive status indicators to verify that the hard drive is installed
properly (the Hard Drive Status LED is located to the immediate right of the
hard disk drive).
v
When the amber LED is on continuously, the hard drive has failed.
v
When the green LED flashes slowly (one flash per second), the hard drive is
being rebuilt.
v
When the green LED flashes rapidly (three flashes per second), the controller
is identifying the hard drive.
7. If your appliance is a Model 200, close and lock the appliance door.
Chapter 3. Adding and replacing components
47