IBM THINKPAD X40, Руководство по техническому обслуживанию аппаратной части

Страница: 63 / 143

Symptom or error FRU or action, in sequence
0182
Bad CRC2. Enter BIOS Setup
and load Setup
defaults.—Checksum of the
CRS2 setting in the EEPROM
is not correct.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save current
setting by pressing F10.
2. System board.
0185
Bad startup sequence settings.
Enter BIOS Setup and load
Setup defaults.
1. Run IBM BIOS Setup
Utility. Press F9, and
Enter to load the default
setting. Then save current
setting by pressing F10.
0187
EAIA data access
error—EEPROM access (read
or write) is failed.
System board .
0188
Invalid RFID Serialization
Information Area or Bad
CRC2—EEPROM checksum is
not correct (block #0,1).
EEPROM CRC2 is not correct
(block #6).
System board .
Replace planar. Box serial
number needs to be reinstalled.
0189
Invalid RFID configuration
information area—EEPROM
checksum is not correct (block
#4,5).
System board .
Replace planar. UUID needs to
be reinstalled.
0190
Critical low-battery error
1. Charge the battery pack .
2. Battery pack.
0191
System Security—Invalid
Remote Change requested.
1. Run IBM BIOS Setup
Utility, and then save
current setting by
pressing F10.
2. System board.
0192
System Security—IBM
Embedded Security hardware
tamper detected.
System board.
0193
RF antenna has been
removed—RFID antenna has
been removed, which was once
installed.
RFID model only supervisor
password .
0194
The computer has been carried
through a security gate—The
computer is carried through the
security gate (portal gate).
RFID model only supervisor
password .
(continued)
Symptom-to-FRU index
58
ThinkPad X40 (2369, 2370, 2371, 2372, 2382, 2386)