IBM ThinkPad 390, Руководство по техническому обслуживанию аппаратной части

Страница: 19 / 101

Safety Information
The following section contains the safety information that
you need to be familiar with before servicing an IBM
mobile computer.
General Safety
Follow these rules to ensure general safety:
Ÿ
Observe good housekeeping in the area of the
machines during and after maintenance.
Ÿ
When lifting any heavy object:
1. Ensure you can stand safely without slipping.
2. Distribute the weight of the object equally
between your feet.
3. Use a slow lifting force. Never move suddenly
or twist when you attempt to lift.
4. Lift by standing or by pushing up with your leg
muscles; this action removes the strain from the
muscles in your back.
Do not attempt to lift any
objects that weigh more than 16 kg (35 lb) or
objects that you think are too heavy for you.
Ÿ
Do not perform any action that causes hazards to the
customer, or that makes the equipment unsafe.
Ÿ
Before you start the machine, ensure that other
service representatives and the customer's personnel
are not in a hazardous position.
Ÿ
Place removed covers and other parts in a safe
place, away from all personnel, while you are ser-
vicing the machine.
Ÿ
Keep your tool case away from walk areas so that
other people will not trip over it.
Ÿ
Do not wear loose clothing that can be trapped in the
moving parts of a machine. Ensure that your sleeves
are fastened or rolled up above your elbows. If your
hair is long, fasten it.
Ÿ
Insert the ends of your necktie or scarf inside clothing
or fasten it with a nonconductive clip, approximately 8
centimeters (3 inches) from the end.
Ÿ
Do not wear jewelry, chains, metal-frame eyeglasses,
or metal fasteners for your clothing.
Attention: Metal objects are good electrical conduc-
tors.
Ÿ
Wear safety glasses when you are: hammering,
drilling soldering, cutting wire, attaching springs, using
solvents, or working in any other conditions that might
be hazardous to your eyes.
Ÿ
After service, reinstall all safety shields, guards,
labels, and ground wires. Replace any safety device
that is worn or defective.
Ÿ
Reinstall all covers correctly before returning the
machine to the customer.
Introduction
11