IBM System x3755Types 7163, Руководство по диагностике и обслуживанию

Страница: 76 / 210

Battery
RAID controller
Battery cable
Battery cable
connector
1. Read the safety information that begins on page vii and “Installation guidelines”
on page 37.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables necessary to replace the device.
3. Remove the top cover (see “Removing the top cover” on page 41).
4. If the controller is a ServeRAID-8k SAS controller, disconnect the battery from
the controller; then, lift the battery out of the mounting bracket on the server wall
and remove the battery from the server.
5. Open the retaining clip on each end of the connector and remove the controller
from the connector.
6. If you are instructed to return the ServeRAID-8k or ServeRAID-8k-l SAS
controller, follow all packaging instructions, and use any packaging materials for
shipping that are supplied to you.
Replacing the ServeRAID-8k or ServeRAID-8k-l SAS controller
To install the replacement ServeRAID-8k or ServeRAID-8k-l SAS controller,
complete the following steps:
1. Open the retaining clip on each end of the connector.
2. Touch the static-protective package that contains the controller to any unpainted
metal surface on the outside of the server; then, remove the controller from the
package.
3. Turn the controller so that the keys align correctly with the slot.
4. Insert the controller into the connector by aligning the edges of the controller
with the slots at the ends of the connector.
Attention: Incomplete insertion might cause damage to the server or the
controller.
60
IBM System x3755 Type 8877 and 7163: Problem Determination and Service Guide