IBM System x iDataPlex dx340, Руководство по диагностике и обслуживанию

Страница: 88 / 196

System reliability guidelines
To help ensure proper cooling and system reliability, make sure that the following
requirements are met:
v
Each of the drive bays has a drive or a filler panel and electromagnetic
compatibility (EMC) shield installed in it.
v
You have followed the cabling instructions that come with optional adapters.
v
You have replaced a hot-swap drive within 2 minutes of removal.
v The server battery is operational. If the battery becomes defective, replace it
immediately.
v
You have replaced one or both system-board trays within 2 minutes of removal.
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices. To avoid damage,
keep static-sensitive devices in their static-protective packages until you are ready
to install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v The use of a grounding system is recommended. For example, wear an
electrostatic-discharge wrist strap, if one is available.
v
Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v
Do not leave the device where others can handle and damage it.
v
While the device is still in its static-protective package, touch it to an unpainted
metal surface on the outside of the rack, chassis, or system-board tray for at
least 2 seconds. This drains static electricity from the package and from your
body.
v Remove the device from the package and install it directly into the system-board
tray without setting down the device. If it is necessary to set down the device, put
it back into the static-protective package. Do not place the device on the
system-board tray cover or on a metal surface.
v
Take additional care when handling devices during cold weather. Heating reduces
indoor humidity and increases static electricity.
Returning a device or component
If you are instructed to return a device or component, follow all packaging
instructions, and use any packaging materials for shipping that are supplied to you.
72
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide