IBM System x iDataPlex dx340, Руководство по диагностике и обслуживанию

Страница: 154 / 196

Installing an I/O enclosure configured with 2.5-inch hot-swap hard disk
drives
To install an I/O enclosure that is configured with 2.5-inch hot-swap hard disk
drives, complete the following steps.
1. Install the PCIe riser-card assembly (see “Installing a PCIe riser-card assembly
in the I/O enclosure” on page 148).
2. Install the PCIe adapters, if you removed any (see “Installing an adapter in the
I/O enclosure” on page 103).
3. Install the I
2
C multiplexer card (see “Installing an I
2
C multiplexer card” on page
105).
4. Install the 2x2 2.5-inch hot-swap SAS backplane (see “Installing a 2x2 2.5-inch
hot-swap SAS backplane” on page 126).
5. Install the 2.5-inch hot-swap drive cage (see “Installing a 2.5-inch hot-swap
drive cage” on page 97).
6. Install the power-supply paddle card, if you removed one (see “Installing a
power-supply paddle card in an expansion enclosure” on page 118).
7. Install the hard disk drives, if you removed any (see “Removing and installing a
hard disk drive” on page 88).
8. Install the I/O enclosure on the system-board tray (see “Installing an expansion
enclosure on a system-board tray” on page 74).
138
System x iDataPlex dx340 Types 6385, 6386, 6389, 7831, 7832, and 7834: Problem Determination and Service Guide