IBM System Storage TS2240, Руководство по установке, эксплуатации и обслуживанию

Страница: 109 / 141

Tape Tangled along Tape Path
1. Carefully pull out excess tape and untangle.
Note: If you find the tape to be broken, go to one of the following appropriate
procedures:
v “Tape Spooled off Supply Reel” on page E-7
v
“Tape Pulled from or Broken near Leader Pin” on page E-8
--OR--
“Tape Broken in Mid-tape” on page E-9
2. Set the drive on its left side with the head and tape path facing up.
1
Loader motor worm gear
3
Takeup reel motor
2
Outer guide rail
WARNING: DO NOT
TOUCH
4
Supply reel motor
3. Turn the supply reel (
4
in Figure E-10) clockwise.
4. Continue spooling into the cartridge until the tape is taut and remains within the
flanges of the tape guiding rollers. turn the supply reel (
4
in Figure E-10) 10
turns. Ensure that you do not stretch the tape.
5. Reassemble the chassis by following the steps in “Removing a Drive from an
Enclosure” on page E-1.
6. Allow the drive to perform mid-tape recovery. This takes several minutes. When
this activity completes, push the Unload button to eject the cartridge.
3
4
1
2
a82hd002
Figure E-10. Rewinding tape into cartridge
Appendix E. Information for Trained Service Personnel
E-11