IBM SYSTEM STORAGE EXP3000 - INTEROPERABILITY MATRIX..., Инструкция по установке и эксплуатации

Страница: 17 / 52

Features and operating specifications
Table 3 contains a summary of the features and operating specifications for the
EXP3000. Depending on your EXP3000 model, some features might not be
available, or some specifications might not apply.
Table 3. Features and operating specifications
General:
v Modular components
– High-capacity disk drives
– Enclosure Services Module
(ESM)
– Power supplies with built-in fan
units
v Technology
– Supports disk array technology
– SAS host interface, redundant
data storage, power and cooling
system, and ESMs
– Hot-swap technology for hard
disk drives, power supplies, and
ESMs
v
User interface
– Built-in power, activity, and fault
LEDs, identification labeling on
components, rear LEDs, and
connectors
– Easy-to-replace hard disk drives,
power supplies with built-in fan
units, and ESMs
Hard disk drive storage:
v
Current capabilities:
– Maximum hard disk drives per
EXP3000: 12
ESMs:
v Technology and interfaces:
– SAS
– SAS interface: Two 26-pin,
mini-SAS connectors
Acoustical noise emissions:
For maximum system configurations
(12 hard disk drives installed).
v Sound power (idling):
– 6.2 bels (maximum)
v Sound power (operating):
– 6.2 bels (maximum)
v Sound pressure (idling):
– 48 dBA (maximum)
v
Sound pressure (operating):
– 48 dBA (maximum)
AC power supply with built-in fan:
v
The EXP3000 comes with two
hot-swap 515 watt (115 - 230 V
ac) power supplies.
v
The two power supplies provide
redundant power to the EXP3000.
Size:
v
Height: 8.7 cm (3.43 in.)
v
Depth: 55.0 cm (21.6 in.)
v
Width: 44.7 cm (17.6 in.)
v
Weight: approximately 36.6 kg
(16.6 lb) for a standard unit. When
fully configured 27.2 kg
(60 lb)
Environment:
v
Air temperature:
– EXP3000 on: 10° to 35°C
(50.0° to 95°F); altitude: 30.5
(100 ft) below to 3000 m (9840
ft) above sea level;
temperature change: 10°C
(18°F) per hour
– EXP3000 off: 10° to 50°C
(14.0° to 120.0°F); maximum
altitude: 3000 m (9840 ft);
temperature change: 15°C
(27.0°F) per hour
Environment cont.
v Humidity:
– EXP3000 on: 20% to 80%
– EXP3000 off: 10% to 90%
– Maximum dew point: 26°C (79°F)
– Maximum humidity gradient: 10%
per hour
Heat output
Approximate heat output in British
thermal units (Btu) per hour:
v Minimum configuration: 205 Btu
(60 watts)
v Maximum configuration 1235 Btu
(361 watts)
Electrical input:
v Sine-wave input (50-60 Hz) required
v
Input voltage low range:
– Minimum: 90 V ac
– Maximum: 136 V ac
v Input voltage high range:
– Minimum: 198 V ac
– Maximum: 264 V ac
v Input kilovolt-amperes (kVA),
approximately:
– Minimum: 0.06 kVA
– Maximum: 0.38 kVA
Notes:
1. Power consumption and heat
output vary depending on the
number and type of optional
features installed and the
power-management optional
features in use.
2. These levels were measured in
controlled acoustical environments
according to the procedures
specified by the American National
Standards Institute (ANSI) S12.10
and ISO 7779 and are reported in
accordance with ISO 9296. Actual
sound-pressure levels in a given
location might exceed the average
values stated because of room
reflections and other nearby noise
sources. The declared sound-power
levels indicate an upper limit, below
which a large number of computers
will operate.
Chapter 1. Introduction
5