IBM System Storage DS3000, Руководство по программированию

Страница: 113 / 652

Parameters
Parameter Description
drives
The drives that you want to assign to the disk pool that
you want to create. For high capacity drive enclosures,
specify the enclosure ID value, the drawer ID value, and
the slot ID value for each drive that you assign to the
disk pool. For low-capacity drive expansion enclosures,
specify the enclosure ID value and the slot ID value for
each drive that you assign to the disk pool. Enclosure ID
values are
0
to
99
. Drawer ID values are
1
to
5
. Slot ID
values are 1 to 32 . Enclose the enclosure ID values, the
drawer ID values, and the slot ID values in parentheses.
driveType
The type of drive that you want to use in the disk pool.
You cannot mix drive types.
You must use this parameter when you have more than
one type of drive in your storage subsystem.
Valid drive types are:
v
fibre
v
SATA
v SAS
If you do not specify a drive type, the command defaults
to
fibre .
userLabel
The name that you want to give the new disk pool.
Enclose the disk pool name in double quotation marks ("
").
driveCount
The
driveCount
parameter limits the disk pool
candidates to the given number. When using this
parameter, the minimum value that you can enter is
11
.
Use this parameter only when the
driveType
parameter
is specified.
warningThreshold The percentage of storage capacity at which you receive
a warning alert that the disk pool is nearing full. Use
integer values. For example, a value of
60 means 60
percent.
The default value is
50
.
Setting this parameter to
0
disables warning alerts.
If you set this to default, the warning alert threshold
value is determined by the controller firmware.
criticalThreshold
The percentage of storage capacity at which you receive
a critical alert that the disk pool is nearing full. Use
integer values. For example, a value of
70
means 70
percent.
The default value is 85 .
Setting this parameter to 0 disables both warning alerts
and critical alerts.
If you set this to default , the critical alert threshold value
is determined by the controller firmware.
Chapter 3. Script Commands
3-67