IBM Storwize V3700, Быстрое руководство по установке

Страница: 40 / 82

Installing an 8 Gbps Fibre Channel 4-port host interface card
If you purchased an FC ACHK 8 Gbps Fibre Channel 4-port host interface card
that was not preinstalled for you, you must install it in the node canister.
Before you begin
The 8 Gbps Fibre Channel 4-port host interface card is installed in the node
canisters in the control enclosure. If your control enclosure has two node canisters,
you must install the same options in
both canisters. Do not start installation until
you have two of the 8 Gbps Fibre Channel 4-port host interface card options.
About this task
Note: The host interface card has four ports, but only two small form-factor
pluggable (SFP) transceivers are installed.
Procedure
To install the host interface card, complete the following steps.
1. Remove the SFP transceivers from the host interface card (Figure 14). To
remove an SFP transceiver, swing the release handle open and use it to pull
the transceiver out of the port.
v3500166
Figure 14. Host interface card and SFP transceivers
20
Storwize V3700: Quick Installation Guide
|
|
|
|
|