2 of 4
Table 1
describes the connectors on the
ServeRAID M1015 controller.
Table 1
Jumpers and Connectors
Step 4
Install the Controller on the Motherboard
Insert the controller in a PCI Express slot on the
motherboard, as shown in
Figure 2
.
Press down gently but firmly to seat the card
correctly in the slot. Secure the controller to the
computer chassis with the bracket screw.
Note:
This is a PCI Express x8 card and it can operate
in x8 or x16 slots. However, some PCI-E slots
support only PCIe graphics cards; if a RAID
controller is installed, it will not function.
Note:
Refer to your motherboard guide for information
about the PCI Express slot.
Figure 2 Installing the ServeRAID M1015 SAS/
SATA Controller
Step 5
Configure and Install the SAS Devices, SATA
II Devices or Both
Configure the SAS devices, SATA II devices, or
both, and install them in the external enclosure.
Note
:
Refer to the documentation for the external
devices for pre-installation configuration
requirements.
Note
:
The controllers support SATA II protocols but not
SATA I protocols. All references to SATA in this
guide are to SATA II.
Step 6
Connect the Controller to the SAS Devices,
SATA II Devices, or Both
Connect the cables between the controller and
the SAS devices, SATA II devices, or both. Refer
to the external device documentation to view
connector locations for the external devices.
Note
:
Refer to the
ServeRAID M1015 SAS/SATA
Controller User’s Guide
for information about the
cables and the connectors.
Step 7
Turn on the Power to the Computer
Reinstall the computer cover and reconnect the
power cords.
Turn on the power to the computer, making sure
that the power is turned on to the SAS devices
and the SATA II devices before or at the same
time as the host computer. If the power is turned
on to the computer before it is turned on to the
Jumper/
Connector Type
Description
J1
RISCwatch header 16-pin header
Reserved for IBM use.
J2
CPLD header
10-pin header
Reserved for IBM use.
J3
External LED drive
activity/fault header
4-pin connector
Connects to external, bi-color
LEDs that indicates drive activity
or faults.
J4
x4 Mini-SAS (SFF-
8087) Ports 0–3
internal connector
Connects the cables from the con-
troller to SAS drives or SATA II
drives, or a SAS expander.
J5
x4 Mini-SAS (SFF-
8087) Ports 4–7
internal connector
Connects the cables from the con-
troller to SAS drives or SATA II
drives, or a SAS expander.
J6
PCI Express x8
board edge
connector
x8 interface that provides connec-
tions on both the top and the
bottom of the board.
TP1
Universal Asyn-
chronous Receiver/
Transmitter (UART)
debugging
4-pin connector
Reserved for IBM use.
U1
ServeRAID M1000
Series Advanced
Feature Key header
2-pin connector
Enables support for RAID 5 config-
urations and self-encrypting disks
(SED) when you insert the
ServeRAID M1000 Series
Advanced Feature Key.
85061-03
Edge of
Motherboard
32-bit slots
(3.3 V)
PCI-e
slot
Bracket Screw
64-bit slots
(3.3 V)
Press here
Press here
Содержание ServeRAID M1015 SAS/SATA
Страница 4: ......
