IBM SAN768B-2, Руководство пользователя

Страница: 169 / 228

Attention: A filler panel should be removed only when being replaced with
a port blade or new filler panel. Any slot that is not occupied by a port blade
should be occupied by a filler panel to ensure correct cooling of the chassis
and protection from dust.
6. Install the port blade (“Installing a port or application blade” on page 86).
Remove the protective strip from the blade contacts (if any) before installing
the blade.
7. Repeat steps 1-5 for additional blades, if any.
8. Install the transceivers (“Removing and installing transceivers” on page 108),
and confirm the proper operation of the blade.
9.
Install, group, and route the cables. See “Managing cables” on page 46 for
additional cabling instructions.
Attention: Do not route cables in front of the exhaust vent, which is located
at the top on the port side of the chassis.
10.
Verify the installation (see the appropriate section of Chapter 4, “Monitoring
system components,” on page 53). For information about how to check the
status of hardware components using the CLI, see the
Fabric OS
Administrator's Guide , or the Fabric OS Command Reference , which are located
on the product documentation CD.
11. Reinstall the chassis door. See “Removing and installing the chassis door” on
page 81.
FC3895 - Installing an Encryption Blade (FS8-18)
Attention: Thoroughly review “Planning for encryption (optional)” on page 47
prior to installing the FS8-18 encryption blade. You must also refer to the Fabric OS
Encryption Administrator’s Guide Supporting Tivoli Key Lifecycle Manager (TKLM)
Environments
to successfully complete installation, configuration, and management
of the encryption functionality.
This feature can be installed while the SAN768B-2 is operational.
Note: If three or more FS8-18 encryption blades are installed, four power supplies
are required for redundancy.
Attention: Follow these precautions for all procedures in this section to avoid
damaging the port blades or chassis:
v
Wear a grounded ESD strap when handling a port blade (see “ESD precautions”
on page xix).
v
Carefully remove the protective strip (if any) covering the blade connectors
before installing any blades.
v
Do not force the port blade installation. If the port blade does not slide in easily,
ensure that it is correctly aligned inside the rail guides before continuing.
Installing a port blade with incorrect alignment damages both the chassis and
the replacement part.
v Hold the port blade by the edges of the metal pan. Do not use the ejectors to
hold a port blade.
v
Disassembling any part of a port blade voids the part warranty and regulatory
certifications. There are no user-serviceable parts inside the port blade.
Time required
Less than 20 minutes.
Chapter 6. Installing new features
141