IBM SAN48C-6, Инструкция по установке, обслуживанию и эксплуатации

Страница: 66 / 82

Appendix A. Cable and Port Specifications
CAUTION: We strongly recommend that power cable runs and other potential noise sources be
located as far away as practical from network cabling that terminates at Cisco equipment. In
situations where long parallel cable runs exist, but cannot be separated by at least 3.3 ft. (1 m), we
recommend that you shield these potential noise sources. To avoid interference, the source should
be shielded by housing it in a grounded metallic conduit.
Cables and Adapters
The IBM SAN48C-6 Switch accessory kit includes the following:
• RJ-45-to-RJ-45 rollover cable
• RJ-45-to-DB-9 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 female DTE adapter (labeled Terminal)
• RJ-45-to-DB-25 male DCE adapter (labeled Modem)
Note: Additional cables and adapters can be ordered from your customer service representative.
Console Port
The console port is an asynchronous RS-232 serial port with an RJ-45 connector. You can use the RJ-45-
to-RJ-45 rollover cable and the RJ-45-to-DB-9 female adapter or the RJ-45-to-DB-25 female DTE
adapter (depending on your computer serial port) to connect the console port to a computer running
terminal emulation software.
Console Port Pinouts
The following table lists the pinouts for the console port on the IBM SAN48C-6 switch:
Table 18. Console Port Pinouts
Pin
Signal
1
1
RTS
2 DTR
3 TxD
4 GND
5 GND
6 RxD
7 DSR
8 CTS
1. Pin 1 is connected internally to pin 8.
Connecting the Console Port to a Computer Using the DB-25 Adapter
You can use the RJ-45-to-RJ-45 rollover cable and the RJ-45-to-DB-25 female DTE adapter (labeled
Terminal) to connect the console port to a computer running terminal emulation software. The following
table lists the pinouts for the console port, the RJ-45-to-RJ-45 rollover cable, and the RJ-45-to-DB-25
female DTE adapter:
46 IBM Storage Networking: IBM Storage Networking SAN48C-6 32 Gbps 48-Port Fibre Channel Switch
Installation, Service, and User Guide