IBM SAN384B-2, Инструкция по установке, обслуживанию и эксплуатации

Страница: 137 / 190

closest to the cabinet to allow the middle section to fully extend. Make sure
the spring-loaded pin snaps back into place. The gap between the end of the
load plate middle section and the port side exhaust kit shelf should be no
more than 2.5 cm (1 in.). If the gap is larger than this, either the lift tool is not
positioned close enough to the cabinet, or the load plate middle section is not
fully extended. Adjust as needed.
12. Carefully slide the chassis from the cabinet onto the 24–inch load plate. Center
the chassis on the platform.
13. Release the spring-loaded pins under the load plate, and pull the middle
section of the load plate back into the load plate.
14. Install the retention straps to secure the chassis to the lift tool.
15.
Release the lift tool wheel brake, and move the lift tool away from the cabinet.
16. Lower the load platform to its lowest position.
17.
Use the lift tool to relocate the chassis to the desired location.
Installing the replacement chassis
Attention: Refer to “Rack safety” on page xxii before starting the installation.
svc00169
55 kg ( 121.2 lbs)
>55kg (121.2 lb)
CAUTION:
The weight of this part or unit is more than 55 kg (121.2 lb). It takes
specially trained persons, a lifting device, or both to safely lift this
part or unit. (C011)
The following instructions require that the port-side exhaust kit is already installed.
If the rack does not have this shelf and exhaust duct installed, refer to “Installing
the port-side exhaust kit” on page 18 for complete instructions.
1. Follow the steps in “Unpacking the SAN384B-2” on page 17 to unpack the
replacement chassis.
2.
Follow the steps in “Installing the SAN384B-2 into the cabinet” on page 25 to
complete the installation of the replacement chassis. You can either install the
empty chassis now, or first install the components steps 1-7 (“Installing
components into the new chassis”) before completing the chassis installation.
Note: If you anticipate that the replacement chassis may be shipped to a new
location while installed in the cabinet, it is recommended that you attach
the shipping brackets to any replacement chassis. These shipping
brackets consist of flat mounting plates that are attached to the sides of
the chassis at the blower assembly end, and L-brackets that attach to the
mounting plates and the cabinet vertical rails.
Installing components into the new chassis
Attention: Follow ESD precautions (“ESD precautions” on page xxi) whenever
handling components.
1.
Install the WWN cards and WWN bezel (“Installing the WWN bezel and
WWN card” on page 89.
2. Install the blower assemblies (“Installing a blower assembly” on page 87).
3. Install the power supplies (“Installing a power supply” on page 86).
Chapter 5. Removing and installing components
105