IBM SAN Volume Controller 2145-CF8, Руководство по установке оборудования

Страница: 53 / 101

2. At the rear of the rack, connect one end of the support arm, as shown by
1
in
Figure 24, to the same slide rail to which you plan to attach the
cable-management arm so that you can swing the other end of the support arm
2
toward the rack.
3. Install the L-shaped cable-management stop bracket, as shown by
1
in
Figure 25 on the unattached end of the support arm. Turn the bracket
2
to
secure it to the support arm.
4. To attach the other side of the support arm to the backside of the slide rail, pull
the pin out, as shown by
1
in Figure 26 on page 28, and then slide the
bracket
2
into the slide rail.
2
svc_bb1ka025
1
2
Figure 24. Rack rear: Attaching the SAN Volume Controller 2145-CF8 cable-management
support arm
svc_bb1ka030
1
2
Figure 25. Rack rear: Installing the SAN Volume Controller 2145-CF8 cable-management
stop bracket
Chapter 2. Installing the SAN Volume Controller 2145-CF8 hardware
27