IBM RS/6000 44P Series 270, Руководство пользователя

Страница: 44 / 216

Unloading the 8 mm Tape Cartridge
Before you perform the unload operation, make sure the power to the system unit is on.
1 Window side of tape cartridge
2 8 mm tape cartridge
3 Write-protect tab
4 Unload button
To unload and eject the tape cartridge, press the unload button. The service processor
rewinds the tape, then ejects the tape cartridge from the tape drive. After you press the
unload button, the following actions occur:
v
The ready status light goes off.
v
The read/write status light flashes during the unload operation.
v
The read/write status light goes off when the cartridge is ejected from the tape drive.
The time required for a tape to rewind and unload is between 18 seconds and 3
minutes, depending on the position of the tape when you push the unload button.
If a fault or an error condition occurs and you cannot eject the tape, press the unload
button for approximately 15 seconds to reset the drive. If the tape cartridge cannot
unload and has to be removed manually from the drive, contact your service
representative.
26
44P Series Model 170 User’s Guide