IBM RS/6000 44P Series 270, Руководство пользователя

Страница: 136 / 216

The ’Supplemental Restart Policy’, if enabled, is used when the O/S Defined Restart
Policy is undefined, or is set to False.
When surveillance detects operating system inactivity during restart, an enabled
’Supplemental Restart Policy’ causes a system reset and the reboot process begins.
v
Call-Out Before Restart(on/off)
When enabled, Call-Out Before Restart allows the system to call out (on a serial port
that is enabled for call out) when an operating system restart is initiated. Such calls
can be valuable if the number of these events becomes excessive, thus signalling
bigger problems.
v
Enable Unattended Start Mode (1=Yes, 0=No)
When enabled, ’Unattended Start Mode’ allows the system to recover from the loss
of ac power.
If the system was powered on when the ac loss occurred, the system reboots when
power is restored. If the system was powered off when the ac loss occurred, the
system remains off when power is restored.
You can access this service aid directly from the AIX command line by typing:
/usr/lpp/diagnostics/bin/uspchrp -b
Configure Remote Maintenance Policy
The Remote Maintenance Policy includes modem configurations and phone numbers to
use for remote maintenance support. Use this service aid to display and change the
following settings for the Remote Maintenance Policy.
Note: Some of the following settings may not be displayed by this service aid.
v
Configuration File for Modem on S1 Configuration File for Modem on S2
Enter the name of a modem configuration file to load on either serial port 1 (S1) or
serial port 2 (S2). The modem configuration files are located in the directory
/usr/share/modems. If a modem file is already loaded, a
′
Modem file currently
loaded
message displays.
v
Modem file currently loaded on S1 Modem file currently loaded on S2
This is the name of the file that is currently loaded on serial port 1 or serial port 2.
Note: These settings are only shown when a modem file is loaded for a serial port.
v
Call In Authorized on S1 (on/off) Call In Authorized on S2 (on/off)
Call In allows the Service Processor to receive a call from a remote terminal.
v
Call Out Authorized on S1 (on/off) Call Out Authorized on S2 (on/off)
Call Out allows the Service Processor to place calls for maintenance.
v
S1 Line Speed S2 Line Speed
A list of line speeds is available by using ’List’ on the screen.
v
Service Center Phone Number
Telephone number of the service center computer. The service center usually
includes a computer that takes calls from systems with call-out capability. This
118
44P Series Model 170 User’s Guide