IBM RS/6000 44P 170, Руководство по установке

Страница: 40 / 86

6. Remove any adapters that prevent access to the battery, as described in “Removing
Adapters” on page 36.
7. Pry the battery out of its mount using your fingernail or a small, blunt object. After
the top of the battery has cleared the plastic mount, pull it up and out of the system.
Note: You may need to pry the battery out of the mount after the top of the battery
has cleared the battery mount.
Do not wiggle the plastic mount from side to
side or try to separate the plastic battery mount from the system board. The
plastic mount connections are soldered to the system board.
Permanent
damage may result to the system board if the battery mount is damaged or
removed.
System customizations, such as passwords, and time and date settings, may be lost
when the battery is removed.
Replacing the Battery
Note: If possible, use a cloth or tissue to handle the new battery. Body oils can cause
early battery failure.
1. Ensure that the battery polarity is correct. With the positive (+) side of the
battery facing the memory module connectors, insert the battery between
the front and rear battery mount clips.
2. Using your thumb, gently press the battery into the battery mount. Use your
index finger to support the back of the battery mount during this step.
3. Replace adapters, if you removed any.
Rear Battery Clip Rear Battery Clip
Memory
Module
Connectors
Memory
Module
Connectors
Plastic Battery Mount Plastic Battery Mount
Battery
28
44P Series Model 170 Installation Guide