IBM Rear Door Heat eXchanger V2, Руководство по установке и обслуживанию

Страница: 46 / 104

14. With the three required people (one person on each end and one person in the
middle), rotate the heat exchanger 90° and up onto the three rectangular
packing inserts.
15. With one person holding the heat exchanger steady on the package inserts,
have another person remove the inner and outer hose access panels. Push
the panels up and out to remove them. See 14. Set the hose access panels
aside.
16. Position one person on each end of the heat exchanger. Have each person
grasp and hold the under side of the heat exchanger with one hand and hold
the top of the heat exchanger with the other hand. Position the third person in
the middle of the heat exchanger and grasp the heat exchanger by the
handles. Have all three people carefully lift the heat exchanger and carry it to
the rear of the rack.
Outer hose
access panel
Inner hose
access panel
Figure 23. Rotating the heat exchanger 90° and removing the hose access panels
36
Rear Door Heat eXchanger V2: Installation and Maintenance Guide