IBM RDX, Руководство пользователя

Страница: 17 / 44

Chapter 2. Installing the RDX drive
This chapter provides installation instructions for the internal RDX drive (see
“Installing an internal RDX drive dock” on page 8) and the external RDX drive
(see “Installing the external RDX drive dock” on page 9). Depending on the server,
you might need a standard or Philips screwdriver to remove the server cover and
install the drive in your server.
Installation guidelines
Before you remove or replace a device, read the following safety information:
v
Read the safety information that begins on page v and “Handling static-sensitive
devices.” This information will help you work safely.
Attention: Take standard electrostatic discharge precautions when you work
inside the server.
v
Observe good housekeeping in the area where you are working. Place removed
covers and other parts in a safe place.
v Make sure that you have an adequate number of properly grounded electrical
outlets for the server and all attached devices.
v Back up all important data before you make changes to disk drives.
v
For rack mount applications, RDX drive should not be used on the hot aisle side
of the rack due to the server preheating.
Handling static-sensitive devices
Attention: Static electricity can damage electronic devices. To avoid damage, keep
static-sensitive devices in their static-protective packages until you are ready to
install them.
To reduce the possibility of damage from electrostatic discharge, observe the
following precautions:
v
Limit your movement. Movement can cause static electricity to build up around
you.
v The use of a grounding system is recommended. For example, wear an
electrostatic-discharge wrist strap, if one is available.
v
Handle the device carefully, holding it by its edges or its frame.
v Do not touch solder joints, pins, or exposed circuitry.
v
Do not leave the device where others can handle and damage it.
v While the device is still in its static-protective package, touch it to an unpainted
metal surface for at least 2 seconds. This drains static electricity from the
package and from your body.
v
Remove the device from its package and install it immediately without setting
down the device. If it is necessary to set down the device, put it back into its
static-protective package. Do not place the device on a metal surface.
v
Take additional care when you handle devices during cold weather. Heating
reduces indoor humidity and increases static electricity.
© Copyright IBM Corp. 2012
7