IBM NetVista 8302, Руководство по техническому обслуживанию аппаратной части

Страница: 53 / 314

The following illustration shows the locations of parts on the system board.
1
Microprocessor
9
Battery
2
DIMM connector 1
10
Clear CMOS/Recovery jumper
3
DIMM connector 2
11
SCSI LED connector
4
Power connector
12
PCI slots
5
Diskette drive connector
13
Front panel audio connector
6
Primary IDE connector
14
CD-ROM audio connector
7
Front panel connector
15
AGP slot (some models)
8
Secondary IDE connector
16
Serial connector
Installing memory
Your computer has two connectors for installing dual inline memory modules
(DIMMs) that provide up to a maximum of 2.0 GB of system memory.
When installing DIMMs, the following rules apply:
v
Fill each system memory connector sequentially, starting at DIMM connector 1.
v
Use 2.5 V, 184-pin, 266 MHz double data rate synchronous dynamic random
access memory (DDR SDRAM).
v Use 128 MB, 256 MB, 512 MB or 1.0 GB (when available) DIMMs in any
combination.
v
DIMMs are 38.1 mm (1.5 inches) in height.
Note: Only DDR SDRAM DIMMs can be used.
To install a DIMM:
1.
Remove the cover. See “Removing the cover” on page 40.
2. To locate the DIMM connectors. See “Identifying parts on the system board” on
page 44.
Chapter 5. Installing Options
47