Non-SL CPU
The Non-SL CPU’s green features are the same as the SL CPU’s except
there is an additional option “IRQ 12, IRQ 15 or Hw/Pin for PM Mode”. If
you select “IRQ 12 or IRQ 15”, the Non-SL CPU will use IRQ which you
select to pass program execution to a Power Management Service Routine.
If you select “ Hw/Pin “ the Power Management will be under chipset
hardware control, and only one Power Management modes, Standby, is
available.
Note:Not like the SL CPU’s SMI(System Management Interrupt), the IRQ
interrupt routine could be replaced by certain Operating System and
Application softwares which will cause the Power Management
functioning improperly or not at all. If this occurs, you should use
"Hw/Pin” instead of “IRQ 12 or IRQ 15”.
Standby Timer
:
Range from “10 Sec” to “1 Hr” and “Disabled”, press
<Esc> to return to the Setup Menu.
Utility Menu
The Utility menu contains three icons:“Detect Master” icon and “Detect
Slave” icon and “Color Set” icon. Detect Master icon is used to auto-detect
the type of hard disk C and Detect Slave icon is used to auto-detect the
type of hard disk D. Color Set icon is used to set the Menu screens color.
There are four choicc:LCD, Army, Pastel and Sky. Select the icon by using
the
/
keys, then press <Enter> to start an auto-detected
function. After completing the detection, it display the detected parameters
in the type 47 and allows you to accept or reject these parameters.
Содержание Mother Board 486F39X
