IBM MICRO TOWER 2169, Руководство по техническому обслуживанию аппаратной части

Страница: 79 / 157

77
Table 2-1 BIOS Error Codes, Messages, and Beeps List
BIOS Error Codes,
Messages, beeps Action/FRU
NOTE: To diagnose a problem, first find the BIOS error
messages, codes, or beeps in left column. If directed to a
check procedure, replace the FRU indicated in the check
procedure. If no check procedure is indicated, the first
Action/FRU listed in right column is the most likely cause.
Secondary master
hard disk failure
Secondary slave hard
disk failure
A warning message to indicate there
has been change of IDE Primary
(Secondary) Channel Master (Slave)
device.
Load default settings in Setup.
Check IDE drive jumper. See ”3.5-In.
Hard Disk Drive Jumper Locations” on
page 133.
IDE drive power.
IDE drive cable/connection.
IDE drive.
Hard Disk(s) failure
(40) Hard Disk Drive controller diagnostics
failed.
Non-System disk or
disk error
Replace and strike
any key when ready
Insert a system disk into Drive A: and
press <
Enter >.
If you assumed the system would boot
from the hard drive, make sure the
controller is inserted correctly and all
cables are properly attached.
Be sure the disk is formatted as a boot
device. Then reboot the system.