IBM MICRO TOWER 2169, Руководство по техническому обслуживанию аппаратной части

Страница: 57 / 157

55
Suspend Type Default: Stop Grant
If this item is set to the default "Stop Grant", the CPU will go into
the Idle Mode.
MODEM Use IRQ Default: 3
If you want an incoming call on a modem to automatically
resume the system from a power-saving mode, use this item to
specify the interrupt request line (IRQ) that is used by the
modem. You might have to connect the fax/modem to a
mainboard Wake On Modem connector for this feature to work.
Suspend Mode Default: Disabled
If you have selected User Define for the Power Management
item, you can set this item to a timeouts from 1 Min to 1 Hour.
The system will go into the power-saving suspend mode if the
timeout passes without any system activity.
HDD Power Down Default: Disabled
If you have selected User Define for the Power Management
item, you can set this item to a selection of timeouts from 1 to
15 minutes. The hard disk drive will power down if the selected
timeout passes without any activity on the hard disk.
Soft-Off by PWR-BTTN Default: Delay 4
Seconds
Under ACPI (Advanced Configuration and Power management
Interface) you can create a software power down. In a software
power down, the system can be resumed by Wake Up Alarms.
This item lets you install a software power down that is
controlled by the normal power button on your system. If the
item is set to Instant-Off, then the power button causes a
software power down. If the item is set to Delay 4 Sec. Then
you have to hold the power button down for four seconds to
cause a software power down.
Wake Up by PCI Card Default: Disabled
If you enable this item, it allows activity on an add-in card in one
of the PCI slots to resume the system from a power-saving
mode.
Power On by Ring Default: Disabled
If this item is enabled, it allows the system to resume from a
software powerdown or a power-saving mode whenever there is
an incoming call to an installed fax/modem. You might have to
connect the fax/modem to a mainboard Wake On Modem
connector for this feature to work.
Wake Up On LAN Default: Enabled
If this item is enabled, it allows the system to resume from a
software powerdown or a power-saving mode whenever there is
an incoming traffic to a network (LAN) adapter. You might have
to connect the LAN card to a mainboard Wake On LAN
connector for this feature to work.