IBM LTO, Руководство пользователя

Страница: 16 / 70

Installing the autoloader
To connect the autoloader, do the following:
Note: Refer to the following illustration.
1. If the host computer is connected to a network, check with the system
administrator before turning off power.
2. Properly turn off all attached devices connected to the host computer.
3. Turn off the host computer.
Note:
When installing cables, use care in handling the SCSI pins. These pins
are easily damaged.
4. Install the SCSI jumper cable
«3¬
from the bottom connector on the autoloader
controller card to the left connector on the drive module.
5.
Install the SCSI terminator
«1¬
to the top connector of the controller card.
6. Install the SCSI cable
«4¬
from the SCSI adapter on the host to the remaining
connector on the tape drive module.
7. Connect the power cord,
«2¬
, from the back of the power supply module to a
properly grounded outlet. See .
Note: Remember to remove the internal packaging before turning on the
autoloader.
8.
Go to the front of the autoloader, and turn it on by pressing the power
(standby) switch in the top right corner. After the power-up test completes,
you will see the default Home screen on the front panel display (see “Front
panel view” on page 2).
9. Set the SCSI IDs for the autoloader and drive if there will be a conflict with
the default SCSI IDs.
10. Turn on other devices and then turn on the host.
11. After turning on the autoloader, the following will happen:
v
LED bar (
«5¬
on page 2) flashes solid amber for a few seconds.
v
LED bar flashes green during self-test
v
LED bar flashes green during calibration.
v
LED bar flashes green during inventory of cartridges.
v
LED bar is solid green with Home screen displayed on LCD.
12.
Verify that the autoloader is installed correctly by looking for the autoloader
and drive devices after turning on the host computer.
v
If you are using Microsoft
®
Windows NT
®
, you can see if the autoloader is
recognized by clicking Settings-->Control Panel-->SCSI Adapter and
expanding the device tree to view the autoloader SCSI adapter.
v
Or, during the boot sequence, you can press Cntrl a during the SCSI
adapter configuration. Select SCSI Select Utilities and then select SCSI
Disk Utilitie s to have the computer retrieve the SCSI bus and display all of
the attached SCSI devices.
13.
If you do not already have backup/restore software installed, you can install
the complementary trial software of your choice by inserting the CD into your
8
LTO Autoloader: User’s Guide