IBM LTO Ultrium 4, Инструкция по установке и эксплуатации

Страница: 43 / 92

2. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page 18.
3.
Press the unload button once per second until
7
appears in the
single-character display (SCD). If you cycle past
7
, continue to press the
unload button until it displays again.
4. To select the function, press and hold the unload button for three seconds. After
you select the function,
7
flashes and the drive automatically starts the test.
v
If no error is detected, the diagnostic will exit Maintenance Mode,
0
temporarily appears in the SCD, and the drive returns to Operational Mode
(SCD blank, Green Ready/Activity status LED ON, and the Amber Fault
status LED is OFF).
v
If an error is detected, the Fault status LED flashes amber and the drive
posts an error code to the SCD. To determine the error, locate the code in
“Error codes and messages” on page 46. To clear the error, either turn the
power off and then on again, or reboot the drive by pressing and holding the
unload button for 10 seconds.
Function Code 8: Unmake FMR tape
About this task
Function Code
8
erases the field microcode replacement (FMR) data and
rewrites the cartridge memory on the tape. This converts the cartridge into a valid
scratch (blank) data cartridge.
Procedure
1. Place the drive in Maintenance Mode. For instructions, see “Entering
Maintenance Mode” on page 18.
2. Press the unload button once per second until
8
appears in the SCD. (If you
cycle past the desired code, press the unload button once per second until the
code reappears.)
3. Press and hold the unload button for three or more seconds, then release it to
select function
8
. The SCD changes to a flashing
C
.
4.
Insert the FMR data cartridge (or the tape drive exits maintenance mode). The
SCD changes to a flashing
8
. The tape drive erases the firmware on the tape
and rewrites the header in the cartridge memory to change the cartridge to a
valid scratch (blank) data cartridge:
Note: If you inserted an invalid tape cartridge (e.g. Gen 1, WORM media, or
non-FMR cartridge), error code
7
appears in the SCD and the amber
Fault status LED flashes. If you inserted a write-protected cartridge, or
the media has read-only compatibility (e.g., Gen2 media), error code
P
appears in the SCD. Press the unload button. The tape drive unloads the
cartridge and exits Maintenance Mode after the cartridge is removed.
Chapter 3. Operating
27