IBM L5U, Информация по обслуживанию

Страница: 208 / 295

9-14
TS3400 Tape Library Maintenance Information
13. Package the failed tape drive in the same packaging that the new tape drive was
shipped to you in, and return to IBM.
14. Go to “End of Call” on page 7-26.
Removing the Drive Cover Plate
When a library drive tray is empty, the tray should be covered at all times to prevent
dust, dirt, and airborne particulates from entering the library enclosure to ensure
maximum longevity of the library.
The drive cover plate ( in Figure 9-10) is held in place by a single screw.
Figure 9-10. Drive cover plate retaining screw location
Replacing the Front Bezel
The front bezel is a design panel on the front of the library.
Removal Procedure
1. Take the library offline. See “Taking the Library Offline/Online” on page 7-23.
2. In the Operator Panel top menu, select Unlock Magazine , and press Enter.
3. Select All Magazines , and press Enter.
4. Remove and clearly label the cartridge magazines from the library.
Note: If the cartridge magazines fail to unlock in response to the Unlock
Magazine command from the Operator Panel, you can unlock the
magazines manually. See “Unlocking Cartridge Magazines Manually” on
page 9-4.
5. On the front panel, remove the two screws located on the air vent ( in
Figure 9-11) using the 2 mm hexagonal wrench.
1
a34z0017
1
E05
FC
SHORT-WAV
E
4G
b /
SE
C
PORT
0 P
ORT
1
Enc
2