IBM J15, Руководство пользователя

Страница: 69 / 142

6. Insert the SAS cable into the SAS port until you hear or feel a click. When the cable is successfully
inserted, you cannot disconnect the cable without pulling on the blue tag.
Connecting to a system node
7. Connect the SAS cable to the SAS port with blue tab above the connector (that is, facing towards the
top of the node).
You hear or feel a click when the cable is successfully inserted. You cannot disconnect the cable
without pulling on the blue tag.
8. Route the SAS cables through the cable management arms, as shown in Figure 38 on page 41.
Figure 38. Example of SAS cables routed through the cable management arms (NOTE: SAS cables are
not installed on the left-hand side of expansion canister for the IBM Cloud Object Storage 5U92 disk
enclosure)
9. When both ends of a SAS cable are correctly connected, the green link-LED next to the connected SAS
ports are lit.
For example, Figure 39 on page 41 shows the LEDs of the expansion canister on a 5U92 disk
enclosure. The SAS cable is successfully inserted in to port 1.
Figure 39. SAS cable correctly inserted into the SAS port
Connecting the 5U92 disk enclosures
After you install 5U92 disk enclosures into the rack, you must connect to a IBM Cloud Object Storage
System
™
Controller (4957/8-C10).
About this task
Note: When you insert SAS cables, ensure that the connector is oriented correctly to the node and disk
enclosure.
Chapter 2. Installing the system hardware 41