IBM J15, Руководство пользователя

Страница: 46 / 142

2 Top of shipping box, folded back.
3 Foam protectors
4. Remove the top cover, as described in “Removing the top cover” on page 21.
5. With two or more persons, push the disk enclosure sideways onto an adjacent flat bed lift. Keep the
remaining foam block protectors attached to the enclosure.
6. Remove the support rail kit from the box in which it was shipped ( 1 , as shown in Figure 1 on page
17).
7. Separate the inner section of the support rails and attach them to each side of the expansion
enclosure, as described in steps “3” on page 22 through “5” on page 23 in “ Installing the support
rails for an optional 5U92 disk enclosure ” on page 22.
8. Attach the remaining sections of the support rails to the rack, as described in step “6” on page 23 in
“ Installing the support rails for an optional 5U92 disk enclosure ” on page 22.
9. Move the mechanical lift to the front of the rack. Align the inner section of the rails with the mid
section of the rails that are extending from the rack.
10. On each side, push the inner section and middle section of the rails together until they click and will
no longer separate, as described in step “1” on page 36 in “Installing or replacing a 5U92 disk
enclosure in a rack ” on page 29.
11. Remove the 4U and 1U fascia from the boxes in which they were shipped, as shown in Figure 3 on
page 18.
Figure 3. Packaging for fascia
1 4U fascia (front)
2 1U fascia (power supply units)
12. Attach the 4U and 1U fascia to the front of the enclosure, as described in “Installing or replacing the
fascia” on page 24.
13. Install the drives, as described in “Installing or replacing a drive” on page 25.
14. Replace the top cover, as described in “Installing or replacing the top cover” on page 28.
15. Lower the mechanical lift so that you can remove the remaining foam blocks away from the disk
enclosure.
16. Slide the latch on the side of each rail and push the disk enclosure securely into the rack, as
described in steps “6” on page 37 through “8” on page 37 in “Installing or replacing a 5U92 disk
enclosure in a rack ” on page 29.
17. Remove the cable management arm assembly from its packaging ( 2 in Figure 1 on page 17).
18. Attach the cable management arm, as described in “Installing or replacing the cable-management
arm” on page 37.
19. Connect the SAS cables, as described in “Removing and installing a SAS cable” on page 40.
20. Connect the power cables.
18 IBM Cloud Object Storage System
™
Version 3.15.6: J15 Appliance Manual