IBM iLC400, Руководство пользователя

Страница: 41 / 95

2. Press the cursor left/right button to move to the Information menu.
3.
Press the cursor up/down button to move up and down in the Information
menu. The Information menu is shown below.
The following table shows the options that you will see in the Information menu.
Item Description
Video Information Displays the resolution and refresh rate of
the connected video device.
Software Version Displays information about the firmware
version information.
Lamp Hours Displays lamp hours used information.
Network DHCP Displays Network DHCP status information.
Network IP Address Displays IP address information.
Network Setting Displays the Network Setting menu.
Lamp Mode Toggles between Normal and ECO lamp
modes. ECO mode uses less power but
decreases the lamp brightness
Lamp Hour Reset Reset this item after replacing the lamp. For
more information, refer to “Replacing the
projector lamp” on page A-1
Cancel Resets Lamp Mode to the default setting.
Network Setting menu
To access the Network Setting menu, follow the steps below:
1. Press the Menu button to open the main menu.
2. Press the cursor left/right button to move to the Information men.
3. Press the cursor up/down button to move to Network Setting in the
Information menu.
4.
Press the cursor left/right button or the Enter button to select the Network
Setting menu. An example Network Setting menu is shown below.
5-8
IBM C400 PROJECTOR: User’s Guide