IBM iL2215, Руководство пользователя

Страница: 40 / 78

7.
Install the new lamp module, being sure to align the connectors properly.
8. Push the module in until it is flush with the bottom case of the projector.
9. Tighten the screws on the outside of the module.
10. Replace the lamp-module door by inserting the hooks on the rear of the
lamp-module door into the projector and pressing the lamp-module door
into place. If the lamp-module door does not fit properly or bulges out,
remove the door and reseat the lamp module.
11.
Plug in the power cord to turn the projector back on.
12.
To reset the lamp-hour counter in the Status window, press and hold the
volume - button, then press the menu button (while still holding down
the volume - button) for 5 seconds. Verify that the counter was reset by
pressing the menu button and viewing the counter in the Status window.
Replacing the batteries in the remote control
The life of the batteries depends on how often and how long you use the
remote control. Symptoms of low battery charge include erratic responses
when you use the remote control and a reduced range of operation.
Follow these steps to replace the batteries:
1.
Turn the remote control face down in your hand.
2. Slide the battery cover off the end of the remote control.
3. Remove the old batteries and dispose of them in an environmentally
proper manner.
4. Install two new AAA alkaline batteries. Make sure that you install each in
the correct direction.
5. Slide the battery cover back on to the remote control.
30
iL2215 IBM UltraPortable Data/Video Projector: User’s Guide