IBM iDataPlex dx320 6385, Руководство пользователя

Страница: 47 / 60

3. Under Popular links , click Software and device drivers .
4. Click System x iDataPlex dx320 server to display the matrix of downloadable
files for the system-board tray.
5. From the BMC software, use the information on the CD to install and use the
program.
Configuring the Gigabit Ethernet controller
The Ethernet controller is integrated on the system board. It provides an interface
for connecting to a 10 Mbps, 100 Mbps, or 1 Gbps network and provides full duplex
(FDX) capability, which enables simultaneous transmission and reception of data on
the network. If the Ethernet port in the server supports auto-negotiation, the
controller detects the data-transfer rate (10BASE-T, 100BASE-TX, or 1000BASE-T)
and duplex mode (full-duplex or half-duplex) of the network and automatically
operates at that rate and mode.
You do not have to set any jumpers or configure the controller. However, you must
install a device driver to enable the operating system to address the controller.
Notes:
1. Changes are made periodically to the IBM Web site. The actual procedure might
vary slightly from what is described in this document.
2. To install the device driver for the Ethernet controller, you might need to use an
external USB CD-RW/DVD drive such as the IBM and Lenovo part number
73P4515 or 73P4516.
To find the device driver or updated information about configuring the controller,
complete the following steps:
1. Go to http://www.ibm.com/systems/support/.
2. Under Product support , click System x .
3. Under Popular links , click Software and device drivers .
4. Click System x iDataPlex dx320 server to display the matrix of downloadable
files for the server.
Chapter 4. Configuring the dx320 server
35