IBM H5S, Руководство по установке, эксплуатации и обслуживанию

Страница: 102 / 149

v Pin supplies (
3
). Leader pins and C-clips.
Attention:
v
Use only the IBM Leader Pin Reattachment Kit to reattach the leader pin to the
tape. Other methods of reattaching the pin will damage the tape, the drive, or
both.
v Use this procedure on your tape cartridge only when the leader pin detaches
from the magnetic tape and you must copy the cartridge's data onto another
cartridge. Destroy the damaged cartridge after you copy the data. This
procedure may affect the performance of the leader pin during threading and
unloading operations.
v Touch only the end of the tape. Touching the tape in an area other than the end
can damage the tape's surface or edges, which may interfere with read or write
reliability.
To reattach a leader pin by using the IBM Leader Pin Reattachment Kit, refer to
Figure D-5 and perform the steps below.
1. Attach the leader pin attach tool (
1
) to the cartridge (
2
) so that the tool's
hook (
3
) latches into the cartridge's door (
4
).
2. Pull the tool back to hold the door open, then slide the tool onto the cartridge.
Open the tool's pivot arm (
5
).
To find the end of the tape inside the cartridge, refer to Figure D-6 on page D-5
and perform the steps below.
1.
Attach the cartridge manual rewind tool (
1
) to the cartridge's hub (
2
) by
fitting the tool's teeth between the teeth of the hub. Turn the tool clockwise
Figure D-5. Attaching the leader pin attach tool to the cartridge. To hold the cartridge door open, hook the tool into the
door and pull the tool back.
D-4
TS2250 Tape Drive Setup, Operator and Service manual