IBM FlashSystem 9150, Руководство по установке оборудования

Страница: 17 / 28

Chapter 4. Installing the FlashSystem 9150 enclosure
About this task
CAUTION:
v Load the rack from the bottom up to ensure rack stability. Empty the rack
from the top down.
Procedure
To install an enclosure, complete the following steps.
1.
On either side of the drive assemblies, remove the enclosure end caps by
grasping the handle and pulling the bottom of the end cap free, then clearing
the tab on the top of the enclosure.
2. Align the enclosure with the front of the rack cabinet.
3. Slide the enclosure into the rack along the rails until the enclosure is fully
inserted. (See Figure 10.)
Note: The rails are not designed to hold an enclosure that is partially inserted.
The enclosure must always be in a fully inserted position.
4. Secure each flange on the front of the enclosure with two black M5 screws.
5. Reinstall the left and right end caps. (See Figure 10.) The left end cap has
indicator windows that align with the status LEDs (light-emitting diodes) on
the edge of the enclosure.
v3500047
Figure 10. Inserting the enclosure
© Copyright IBM Corp. 2018
13