IBM
Installation Instructions
33. Attach the available power-cable connector to the back of the drive. If
there is no available connector on the power cable, use one of the power
cables found in the storage trays.
34. If you took the power cable out of the clip on the bottom of the server,
reroute it back under the clip.
Reinstall the power supply:
35. Carefully move the cables out of the way.
36. Tilt the power supply into the server.
37. Press in the retaining knob and turn it to the right until it is tight.
38. Connect all twisted power cables to the power supply.
Note: These cables do not have to be connected in a specific order or to
a particular connector. All of the cables are identical, and all of the con-
nectors are identical.
39. Plug the SCSI cable connector into the connector on the system board.
40. Route the SCSI cable through the fastener on the top of the power supply.
Replace the drive retainer:
3746
PN 29H4179
EC D55911A
EC E46709
FFBM
18 of 24
08 DEC 95
16 MAY 97
18
