IBM
Installation Instructions
20. Install the rail under the drive, using the
four screws.
21. Slide the new drive completely into the
bay (4).
If the drive does not slide all the way into
the Service Processor, it might be upside
down.
Connect the cables to the drive:
22. Connect the signal cable to the drive, with
the terminator in place.
23. Connect the four-wire power-supply cable,
if required, to the drive.
If you have difficulty connecting a cable,
turn the cable connector over and try
again; cable connectors are keyed and
connect only one way.
Reinstall the drive retainer:
24. Place the bottom edge of the drive retainer
on the tabs that stick up from the bottom
of the Service Processor frame.
25. Pivot the drive retainer up until it snaps in
place over the latch.
3746
PN 29H4179
EC D55911A
EC E46709
FFBM
10 of 24
08 DEC 95
16 MAY 97
10
